Installation manual

Monitoring Mode (MOn)
56 S1A28692 03/2010
Parameters described in this page can be accessed by:
MOn- [1.2 MONITORING] (continued)
MpI-
g
[MONIT. PI]
PID management. Visible if [PID feedback ass.] (PIF) is not set to [No] (nO).
rPI
T
g
[Internal PID ref.]
Internal PID reference: As a process value.
rpE [PID error]
g
PID error value.
rpF [PID feedback]
g
PID feedback value.
rpC [PID reference]
g
PID setpoint value via graphic display terminal.
rpO [PID Output]
Hz
PID output value with limitation.
MOn- [1.2 MONITORING] (continued)
pEt- [MONIT. POWER TIME]
ApH [Consumption]
Wh, kWh, MWh
Energy consumption in Wh, kWh or MWh (accumulated consumption).
rtH [Run time]
s, min, h
Run elapsed time display (resetable) in seconds, minutes or hours (length of time the motor has been switched on).
ptH [Power on time]
s, min, h
Power elapsed time display in seconds, minutes or hours (length of time the drive has been switched on).
rpr [Operating t. reset]
T
Reset of run elapsed time.
nO
APH
rtH
PtH
[No] (nO): Reset operation not in progress
[Reset kWh] (APH): Clear [Reset kWh] (APH)
[rst. runtime] (rtH): Clear [rst. runtime] (rtH)
[rst. P On t.] (PtH): Clear [rst. P On t.] (PtH)
MOn- [1.2 MONITORING] (continued)
CnFS
nO
CnF0
CnF1
CnF2
[Config. active]
View of the active configuration.
[In progress] (nO): Transitory state (configuration changing)
[Config. n°0] (CnF0): Configuration 0 active
[Config. n°1] (CnF1): Configuration 1 active
[Config. n°2] (CnF2): Configuration 2 active
CFpS [Utilised param. set]
g
Configuration parameter status (can be accessed if parameter switching has been enabled, see page 214).
nO
CFP1
CFP2
CFP3
[None] (nO): Not assigned
[Set N°1] (CFP1): Parameter set 1 active
[Set N°2] (CFP2): Parameter set 2 active
[Set N°3] (CFP3): Parameter set 3 active
Code Name / Description Unit
DRI- > MON- > MPI-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com