Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 71
Assignment of the inputs/outputs
(1) To start with, integrated Modbus [Modbus Address] (Add) must first be configured, page 257.
Note: These assignments are reinitialized every time the macro configuration changes.
Input/
output
[Start/Stop] [M. handling] [Gen. Use] [Hoisting] [PID regul.] [Network C.]
[AI1] [Ref.1 channel] [Ref.1 channel] [Ref.1 channel] [Ref.1 channel] [Ref.1 channel] (PID
reference)
[Ref.2 channel]
([Ref.1 channel]
= integrated
Modbus) (1)
[AI2] [No] [Summing ref. 2] [Summing ref. 2] [No] [PID feedback] [No]
[AI3] [No] [No] [No] [No] [No] [No]
[AO1] [No] [No] [No] [No] [No] [No]
[R1] [No drive flt] [No drive flt] [No drive flt] [No drive flt] [No drive flt] [No drive flt]
[R2] [No] [No] [No] [Brk control] [No] [No]
[LI1] (2-wire) [Forward] [Forward] [Forward] [Forward] [Forward] [Forward]
[LI2] (2-wire) [Reverse] [Reverse] [Reverse] [Reverse] [Reverse] [Reverse]
[LI3] (2-wire) [No] [2 preset speeds] [Jog] [Fault reset] [PID integral reset] [Ref. 2
switching]
[LI4] (2-wire) [No] [4 preset speeds] [Fault reset] [External fault] [2 preset PID
ref.]
[Fault reset]
[LI5] (2-wire) [No] [8 preset speeds] [Torque limitation] [No] [4 preset PID
ref.]
[No]
[LI6] (2-wire) [No] [Fault reset] [No] [No] [No] [No]
[LI1] (3-wire) [Drive running] [Drive running] [Drive running] [Drive running] [Drive running] [Drive running]
[LI2] (3-wire) [Forward] [Forward] [Forward] [Forward] [Forward] [Forward]
[LI3] (3-wire) [Reverse] [Reverse] [Reverse] [Reverse] [Reverse] [Reverse]
[LI4] (3-wire) [No] [2 preset speeds] [Jog] [Fault reset] [PID integral
reset]
[Ref. 2
switching]
[LI5] (3-wire) [No] [4 preset speeds] [Fault reset] [External fault] [2 preset PID
ref.]
[Fault reset]
[LI6] (3-wire) [No] [8 preset speeds] [Torque limitation] [No] [4 preset PID
ref.]
[No]
[LO1] [No] [No] [No] [No] [No] [No]
Graphic display terminal keys
F1 key [No] [No] [No] [No] [No] Control via
graphic display
terminal
F2, F3, F4
keys
[No] [No] [No] [No] [No] [No]
In 3-wire control, the assignment of inputs LI1 to LI6 shifts.
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com