Installation manual

Configuration Mode (ConF)
S1A28692 03/2010 73
Parameters described in this page can be accessed by:
Full
Code Name / Description Adjustment range Factory setting
COnF [1.3 CONFIGURATION]
FULL [FULL]
SIM- [SIMPLY START]
tCC [2/3 wire control]
[2 wire] (2C)
DANGER
UNINTENDED EQUIPMENT OPERATION
When this parameter is changed, [Reserve assign.] (rrS) and [2 wire type] (tCt) parameters, and all
the assignments involving the logic inputs will revert to their default values.
Check that this change is compatible with the wiring diagram used.
Failure to follow these instructions will result in death or serious injury.
2C
3C
See [2/3 wire control] (tCC) page 112
.
[2 wire] (2C)
2-wire control (level commands): This is the input state (0 or 1) or edge (0 to 1 or 1 to 0), which controls running or stopping.
Example of "source" wiring:
LI1: forward
LIx: reverse
[3 wire] (3C)
3-wire control (pulse commands): A "forward" or "reverse" pulse is sufficient to command starting, a "stop" pulse is sufficient
to command stopping.
Example of "source" wiring:
LI1: stop
LI2: forward
LIx: reverse
CFG [Macro configuration]
[Start/Stop] (StS)
g
DANGER
UNINTENDED EQUIPMENT OPERATION
Check that the selected macro configuration is compatible with the wiring diagram used.
Failure to follow these instructions will result in death or serious injury.
StS
HdG
HSt
GEn
PId
nEt
See [Macro configuration] (CFG) page 70
.
[Start/Stop] (StS): Start/stop
[M. handling] (HdG): Handling
[Hoisting] (HSt): Hoisting
[Gen. Use] (GEn): General use
[PID regul.] (PId): PID regulation
[Network C.] (nEt): Communication bus
2 s
+24 LI1 LIx
ATVppp
+24 LI1 LI2 LIx
ATVppp
2 s
DRI- > CONF > FULL > SIM-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com