Installation manual

Configuration Mode (ConF)
78 S1A28692 03/2010
Parameters described in this page can be accessed by:
(1) Range 0.01 to 99.99 s or 0.1 to 999.9 s or 1 to 6,000 s according to [Ramp increment] (Inr) page 155.
(2) In corresponds to the rated drive current indicated in the Installation manual or on the drive nameplate.
HSP2 [High speed 2]
0 to 599 Hz 50 Hz
g
T
Visible if [2 High speed] (SH2) is not set to [No] (nO). See [High speed 2] (HSP2) page 229.
HSP3 [High speed 3]
0 to 599 Hz 50 Hz
g
T
Visible if [4 High speed] (SH4) is not set to [No] (nO). See [High speed 3] (HSP3) page 229.
HSP4 [High speed 4]
0 to 599 Hz 50 Hz
g
T
Visible if [4 High speed] (SH4) is not set to [No] (nO). See [High speed 4] (HSP4) page 229.
ItH [Mot. therm. current]
0.2 to 1.5 In (2) According to drive rating
T
Motor thermal protection current, to be set to the rated current indicated on the nameplate.
See [Mot. therm. current] (ItH)page 75
.
UFr [IR compensation]
0 to 200% 100%
T
IR compensation. See [IR comprensation] (UFr) page 105.
SLP [Slip compensation]
0 to 300% 100%
g
T
Slip compensation. See [Slip compensation] (SLP ) page 105.
SFC [K speed loop filter]
0 to 100 65
g
T
Speed filter coefficient. See [K speed loop filter] (SFC) page 105.
SIt [Speed time integral]
1 to 65,535 ms 63 ms
g
T
Speed loop integral time constant. See [Speed time integral] (SIt) page 105.
SPG [Speed prop. gain]
0 to 1,000% 40%
g
T
Speed loop proportional gain. See [Speed prop. gain] (SPG) page 105.
SPGU [UF inertia comp.]
0 to 1,000% 40%
g
T
Inertia factor. See [UF inertia comp.] (SPGU) page 105.
Code Name / Description Adjustment range Factory setting
g
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
T
Parameter that can be modified during operation or when stopped.
DRI- > CONF > FULL > SET-
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: [phone]-Outside Local Area: [phone]-www.stevenengineering.com