User`s manual

Software Configuration Examples
02/2005 17
3.1 Introduction of the Software Configuration
Example
Example With Premium PLC and an XPS-MC Safety Controller
Introduction The example shows a configuration with following devices (see also Example With
a Single XPS-MC Safety Controller, p. 10), the values shown in the pictures are the
defaults with which the example was running. You should not change these values
unless neccessary.
Hardware devices:
Premium PLC as PROFIBUS DP MASTER
LUFP7 as gateway for PROFIBUS SLAVE / MODBUS MASTER
XPS-MC as MODBUS SLAVE
Cable, connectors and line termination
Software devices:
ABC LUFP configuration tool (See LUFP7 Gateway with the ABC LUFP
Configuration Tool, p. 18)
SyCon Profibus configuration tool and the relevant GSD (General Slave Data) -
Files (See SyCon Profibus Configuration Tool, p. 36)
Unity Pro XL application software (See Configure Unity Pro (Profibus Master),
p. 44)
XPSMCWIN configuration tool for the XPS-MC Safety Controllers
Note: In the following sections it is assumed, that the hardware is connected and
power is on.