User`s manual

Software Configuration Examples
02/2005 23
Add Commands This example shows how to add all available commands. Infact, to get all the
information it is only necessary to add the holding registers, because the information
from the inputs (command 01 = Read Coil Status) and outputs (command 02 = Read
Input Status) are included. For normal monitoring only, "command 03 = Read
Holding Registers" is sufficient (refer to step 8 and 9). To gain a better
understanding, this procedure shows how to add all three commands.
Step Action
1 Click in the left window on MC32.
Open MC32 in the menu bar and select Add Command.
Add command:
See also Overview of the Information Available From the XPS-MC Safety
Controller, p. 33.