Installation manual

Installation
3–2 152936
This manual is for use by qualified personnel only.
Unloading
Moving the Xantrex GT250 E
To move the Xantrex GT250 E, use a forklift that has a sufficient lift capacity and
has a 66 cm fork span or a crane with a minimum lift capacity of 2000 kg.
Follow Figure 3-2 and Figure 3-3 to locate the balance point (center of gravity
symbol) of various configurations.
To move the Xantrex GT250 E by forklift while it is still inside the shipping
crates:
1. Place the forks of the forklift below the shipping crate at the points specified
on the shipping crate.
2. Pay attention to the balance point (center of gravity) sticker.
3. Lift the Enclosure from beneath the shipping crate.
Unpacking the Xantrex GT250 E
To unpack the Xantrex GT250 E from the shipping crate:
1. Using a claw hammer or pry bar, remove the crate’s wood top and side
panels.
2. Remove the Xantrex GT250 E anchor hardware that attaches it to the
shipping pallet.
WARNING: Heavy Equipment
The Xantrex GT250 E weighs approximately 1160 kg. Attempting to lift the
equipment by other than the recommended lifting points may damage the
equipment or present a personnel safety hazard and void the warranty. Keep all
the doors closed and latched when moving the Enclosures. Leaving the door
latches unsecured may result in damage to the unit and void the warranty.
WARNING: Equipment is heavy
If lifted incorrectly, the Xantrex GT250 E could overbalance and cause personal
injury.
c
CAUTION: Equipment Damage
To move the Xantrex GT250 E, use a forklift that has a sufficient lift capacity and
has a 66 cm fork span.