Installation manual

Unloading
152936 3–3
This manual is for use by qualified personnel only.
Removing the Pallet and Moving the Xantrex GT250 E
Use Figure 3-1 to locate the balance point or center of gravity ( symbol).
Moving with a Forklift
To move the Xantrex GT250 E using a forklift:
1. Place the forks of the forklift below the unit at the points specified in
Figure 3-2.
2. Lift the Xantrex GT250 E from beneath the respective Enclosures.
Be sure to use a forklift with a 66 cm fork span.
3. Remove the pallet from beneath the unit.
4. Once the pallets are removed from the units, use the same lifting locations to
lift the units into the place where they are to be permanently located.
c
CAUTION: Equipment Damage
To move the Xantrex GT250 E, use a forklift that has a sufficient lift capacity and a
66 cm fork span.
Figure 3-1 Center of Gravity
Center of Gravity
Side view