Installation manual

Mounting and Anchoring the Units
152936 3–5
This manual is for use by qualified personnel only.
Mounting and Anchoring the Units
To mount and anchor the Xantrex GT250 E:
1. Predrill the floor or pad to accept masonry anchors for 12 mm bolts, or
ensure it has pre-installed anchoring bolts that will fit the 16 mm mounting
holes. See Figure 2-3 on page 2–6.
2. Lift the Xantrex GT250 E from beneath with a forklift or pallet jack as shown in
Figure 3-2 on page 3–4, or lift the Xantrex GT250 E from above with a crane
as shown in Figure 3-3 on page 3–4. Move the Enclosure into place.
3. Secure the Enclosure feet to the floor with the appropriate anchoring
hardware.
Opening or Closing Access Doors
To lock or unlock the front door on the main inverter:
1. Use the key provided with the unit.
a) Insert the key in the lock and turn clockwise to open or counterclockwise
to lock.
b) Pull the front door open from the center.
Figure 3-4 Inverter Enclosure Access Doors
Main Inverter
Front Door Lock