Installation manual

Remote Communications
152936 3–13
This manual is for use by qualified personnel only.
Remote Communications
The Xantrex GT250 E provides remote communications for system monitoring or
data logging through a personal computer using the Xantrex Solar Graphic User
Interface (GUI) software. The GUI software provides a windows-based interface
program that accesses, monitors, and controls the features and functions of the
unit. The GUI also provides additional data logging and tracking features which
are not available through the UFCU. If multiple inverters are networked together,
the software is capable of tracking up to 50 inverters on the same network.
The PC can be connected to the unit either directly or remotely. Before installing
the GUI software, it will be necessary to determine and establish the proper
communication line to support the desired connection.
A local telephone line is required to use the factory-installed modem.
Telephone Line Connections
To connect telephone service:
1. Unlatch and open the door to the AC interface enclosure.
2. Route the Telephone line through the wiring duct work.
3. Connect the Telephone to the RJ-11 termination. The RJ11 Termination is
located to the right of -F36, see Figure 3-12.
4. Close and latch the door to the AC interface enclosure.
Figure 3-12 Telephone Cable Routing
-F36 Communication
Port