Installation manual

v
This manual is for use by qualified personnel only.
Important Safety Instructions
SAVE THESE INSTRUCTIONS - DO NOT
DISCARD
This manual contains important safety instructions for the Xantrex GT250 E 250
kW Grid-Tied Photovoltaic Inverter (Xantrex GT250 E) that shall be followed
during installation and maintenance procedures.
WARNING: Shock Hazard
Read and keep this Planning and Installation Manual for future reference. Before
installing Xantrex GT250 E read all instructions, cautionary markings, and all
other appropriate sections of this manual. Failure to adhere to these warnings
could result in severe shock or possible death. Exercise extreme caution at all
times to prevent accidents.
WARNING: Shock Hazard
The Xantrex GT250 E Enclosures contain exposed high-voltage conductors. The
Enclosure doors should remain closed with the latches tightened, except during
installation, maintenance or testing. These servicing instructions are for use by
qualified personnel who meet all code requirements for licensing and training for
the installation of Electrical Power Systems with AC and DC voltage to 1000 volts.
To reduce the risk of electric shock, do not perform any servicing other than that
specified in the installation instructions unless you are qualified to do so. Do not
open the cabinet doors if extreme moisture is present (rain or heavy dew).
WARNING: Lethal Voltage
In order to remove all sources of voltage from the Xantrex GT250 E, the incoming
power must be de-energized at the source. This may be done at the main utility
circuit breaker and by opening the AC Disconnect and the DC Disconnect
Switches on the Xantrex GT250 E. Review the system configuration to determine
all of the possible sources of energy. In addition, allow 20 minutes for the DC bus
capacitors, located within the cabinet, to discharge after removing power.