Specifications

Using the System Settings Menu
975-0298-01-01 3–17
Using Cascading Parameters
Xantrex Xanbus-enabled devices are configured one at a time.
However, because devices often have common settings, cascading
parameters can simplify and speed up system configuration. When a
parameter is “cascaded,” a newly configured device setting is applied to
all devices of the same device type on a common AC or DC connection.
For example, if cascading parameters are enabled and a Battery Size (Ah)
parameter is changed on the inverter/charger setup menu, the same
battery size setting is applied to other inverter/chargers that share the
same DC connection in the system.
To enable or disable cascading parameters:
1. On the System Settings menu, with Cascading highlighted,
press Enter.
2. Use the up arrow or down arrow button to change the
current setting—“Enabled” or “Disabled.”
3. Press Enter to select the new setting.
When configuring the network-managed power system with cascading
parameters enabled, you should verify that the configurations have been
cascaded correctly to other devices. Communication errors may cause
parameters to revert to their original values or generate a warning
message on the Xantrex XW SCP screen.
Viewing Device Information
The Device Info screen shows the model number, silicon chip serial
number and firmware revision for each Xantrex Xanbus-enabled device.
You cannot select or change any information on this screen.
To view device information:
1. On the System Settings menu, with View Device Info highlighted,
press Enter.
The Device Info screen appears.
2. Press the down arrow button to view information for each Xantrex
Xanbus-enabled device on the system.
3. Press Exit to return to the System Settings menu.
Device Info
00000DB22578
865-1000
1.00.00