Specifications

Warnings and Faults
975-0298-01-01 4–3
To return to Operating mode:
1. On the System Settings menu, highlight “System Mode,” and
press Enter.
2. Select “Operating” and press Enter.
Using the Standby Button
Pressing the Standby Button produces the same result as disabling
“Invert” and “AC Charge” from the System Settings menu on the Xantrex
XW SCP. Pressing the Standby button does not affect Charge Controller
operation. After disabling inverting and charging with the Standby
button, the system continues to pass AC input through to the loads.
Pressing the Exit and Standby buttons at the same time puts the entire
Xantrex XW power system (including Charge Controllers) into standby
mode. In standby mode, the Xantrex XW inverter/chargers stop passing
AC input through to the loads, and “Stb” is displayed on Inverter
Information Panel.
After the keypress command to enter standby mode, the Xantrex XW
AGS (if installed) shuts down the generator (if it is running) after a
cool-down cycle.
Warnings and Faults
This section describes how fault and warning messages behave,
and what you should do when they appear. For a complete list of fault
and warning messages specific to the Xantrex XW SCP, along with
recommended actions to correct the fault or warning condition, refer to
Chapter 5, “Troubleshooting”.
Important: The Xantrex XW SCP displays fault and warning messages
for all Xantrex Xanbus-enabled devices in the system. For information
about fault and warnings for other devices, refer to the Troubleshooting
chapter in the Owner’s Guide or Operation Guide for each device.