Conext XW PRO 6848 6,800W 48V Installation
Table Of Contents
- Safety Information
- Label Symbols
- Product Labels
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Monitoring Operation
- External Monitoring Control
- Configuration
- Troubleshooting
- Specifications
- Electrical Specifications
- Mechanical Specifications
- Regulatory Approvals
- Grid Support Utility Interactive Functions
- California Rule 21: Smart Inverter Grid-Support Utility Interactive Functions
- Hawaiian Electric Company (HECO) Rule No. 14: Smart Inverter Grid-Support Uti...
- IEEE 1547-2003 Standard for Interconnecting Distributed Resources with Electr...
- Puerto Rico Energy Power Authority (PREPA) Technical Requirements for Interco...
- Defaults
This chapter provides the electrical and mechanical specifications for the Conext XW
Pro.
DISCLAIMER REGARDING STATUS DATA
Status data reported by the Conext XW Pro are approximate values intended to provide
general and non-exact information about the Conext XW Pro. Under no circumstances
should this status data be used for precise evaluation of the Conext XW Pro system
performance, including efficiency considerations. In systems with a single Conext XW Pro,
the measurement capabilities of the inverter/charger allow for deviations of up to 5% of
actual values. In systems with multiple inverter/charger units, the compounded effect of
accuracy deviations in the status data could result in aggregated deviations exceeding 5%
of actual values. For systems requiring higher accuracy status reporting of ac parameters,
Schneider Electric recommends the use of external monitoring equipment of appropriate
and accurate calibration. for higher accuracy measurement of dc (battery) parameters,
Schneider Electric recommends installing an appropriate dc battery monitor in the system.
Electrical Specifications
NOTE: Specifications are subject to change without prior notice.
Specification XW Pro 6848 NA
Continuous Output Power (Inverter Mode @ 25°C) 6,800 W
Continuous Output Power (Inverter Mode @ 40°C) 6,000 W
Surge Rating (Overload for 1 minute) 12,000 W
Surge Rating (Overload for 30 minutes) 8,500 W
Waveform True Sine Wave
Idle Consumption - Inverter Mode, no load 28 W
Idle Consumption - Search Mode < 8 W
DC Input Voltage Range 40 - 64 VDC, 48 VDC nominal
DC Current at Rated Continuous Power (Inverter Mode) 180 A
Maximum Charge Rate (Charger Mode) 140 A
Power Factor Corrected Charging PF 0.98
Compatible Battery Types
Flooded (default), Gel, AGM,
Lithium ion, custom
Battery Bank Range 440 - 10,000 Ah
AC Output Voltage 120/240 V ± 3%
AC Continuous Output Current (Inverter Mode) L-L: 28 A (120/240 V)
AC Continuous Output Current, Imbalanced line loading
on L1-N or L2-N (Inverter Mode)
L-N: 40 A (120 V)
Table 27Conext XW ProElectrical Specifications
Conext XW Pro Owner's Guide Specifications
122 This document is intended for use by qualified personnel 990-91227A-01