Conext XW PRO 6848 6,800W 48V Installation
Table Of Contents
- Safety Information
- Label Symbols
- Product Labels
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Monitoring Operation
- External Monitoring Control
- Configuration
- Troubleshooting
- Specifications
- Electrical Specifications
- Mechanical Specifications
- Regulatory Approvals
- Grid Support Utility Interactive Functions
- California Rule 21: Smart Inverter Grid-Support Utility Interactive Functions
- Hawaiian Electric Company (HECO) Rule No. 14: Smart Inverter Grid-Support Uti...
- IEEE 1547-2003 Standard for Interconnecting Distributed Resources with Electr...
- Puerto Rico Energy Power Authority (PREPA) Technical Requirements for Interco...
- Defaults
Figure 41Conext XW Pro Reactive Power capability
Reactive Power Grid Support
When the Q(V) Volt-VAr function is enabled, the Conext XW Pro is in Grid Support mode.
Reactive power output is actively control as a function of the voltage following the Volt-
Var piecewise linear characteristic in the figure below.
n The Conext XW Pro dynamically injects reactive power into the grid following the
P1P2 segment when AC voltage trends lower than the nominal value
n The Conext XW Pro dynamically absorbs reactive power from the utility grid following
the P5P6 segment when AC voltage trends higher than the nominal value
n By generating or consuming reactive power in response to grid voltage fluctuations,
Conext XW Pro contributes to grid stabilization towards the nominal voltage.
The Q(V) function is enabled by default.
Specifications Conext XW Pro Owner's Guide
990-91227A-01 This document is intended for use by qualified personnel 143