Conext XW PRO 6848 6,800W 48V Installation
Table Of Contents
- Safety Information
- Label Symbols
- Product Labels
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Monitoring Operation
- External Monitoring Control
- Configuration
- Troubleshooting
- Specifications
- Electrical Specifications
- Mechanical Specifications
- Regulatory Approvals
- Grid Support Utility Interactive Functions
- California Rule 21: Smart Inverter Grid-Support Utility Interactive Functions
- Hawaiian Electric Company (HECO) Rule No. 14: Smart Inverter Grid-Support Uti...
- IEEE 1547-2003 Standard for Interconnecting Distributed Resources with Electr...
- Puerto Rico Energy Power Authority (PREPA) Technical Requirements for Interco...
- Defaults
Reconnection (Soft-Start) Ramp Rate
Upon starting up, returning to service, or re-connecting, the Conext XW Pro limits the
rate of exported/generated active power to no larger that the Ramp Rate setting.
Normal Ramp Rate function is enabled by default.
Figure 49Reconnection ramp rate
n Normal Ramp rate is defined as a slope measured in percentage of AC nominal
current per second [%In/sec].
n The default Normal Ramp Rate value is 0.33 [%In/sec] with an adjustability range
from 0.1 to 100 [%In/sec].
Parameter
AC Current per second [%In/s]
Default Range
Ramp Rate 0.33 N/A
Parameter
Time [s] AC Current [%In]
Default Range Default Range
Point P1 0 N/A 0 N/A
Point P2 303 1 to 1000 100 N/A
Conext XW Pro Owner's Guide Specifications
152 This document is intended for use by qualified personnel 990-91227A-01