Conext XW PRO 6848 6,800W 48V Installation
Table Of Contents
- Safety Information
- Label Symbols
- Product Labels
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Monitoring Operation
- External Monitoring Control
- Configuration
- Troubleshooting
- Specifications
- Electrical Specifications
- Mechanical Specifications
- Regulatory Approvals
- Grid Support Utility Interactive Functions
- California Rule 21: Smart Inverter Grid-Support Utility Interactive Functions
- Hawaiian Electric Company (HECO) Rule No. 14: Smart Inverter Grid-Support Uti...
- IEEE 1547-2003 Standard for Interconnecting Distributed Resources with Electr...
- Puerto Rico Energy Power Authority (PREPA) Technical Requirements for Interco...
- Defaults
Monitoring Charger Status
The green LED labelled “A” indicates the Conext XW Pro is charging the battery bank.
When this LED is on, the numeric display screen shows battery charging current in
amps.
Symbol LED On LED Flashing LED Off
The Conext XW Pro
is charging the
battery bank. The
numeric display
screen shows battery
charging current in
amps.
AC coupled
charging is
occurring
a
.
May flash in AC
coupled mode
where reverse
current greater
than 3 A is present.
Multiple units are
connected in
parallel under no
load.
The Conext XW
Pro is not in
charge mode.
When a charge cycle ends or charging is manually disabled, the Conext XW Pro does
not leave charge mode immediately, and the charging LED remains on for 60 seconds.
Monitoring Events
The Red Event LED indicates the presence of a fault or warning in the system. To clear
active events, briefly press and release the STARTUP/SHUTDOWN button n (see Figure 10
on page 34).
Symbol LED On LED Flashing
The Conext XW Pro has stopped
charging or inverting due to a event.
The LED also turns on steadily if the
unit has both a fault and a warning.
The Conext XW Pro has a warning.
A warning may escalate to a fault if
the warning condition does not go
away.
Equalizing Batteries
Button
Pressing the Equalize button ( symbol) for five seconds initiates a battery
equalization cycle. This cycle is used to restore battery capacity when battery life has
deteriorated due to sulphation. After the button is pressed the Conext XW Pro begins a
full charge cycle, which is automatically followed by an equalization cycle. Equalization
functions only when AC is present and qualified and the charger is enabled. Otherwise
the Conext XW Pro generates a Cannot Equalize warning (W96).
a
See the document “AC Coupling of Inverters Solutions Guide” available at http://solar.schneider-
electric.com for more information about AC coupling.
Conext XW Pro Owner's Guide Monitoring Operation
36 This document is intended for use by qualified personnel 990-91227A-01