Conext XW PRO 6848 6,800W 48V Installation

Monitoring Battery Level
When the Conext XW Pro is inverting, the row of five LEDs indicates the approximate
available SOC (State of Charge) of the batteries connected to the system. This capacity
reading is based on battery voltage.
The battery LEDs can retrieve information from various sources depending on the
devices installed in the system. SOC information is reported from one of the following
devices, listed in order of priority:
1. Conext Battery Monitor (If installed)
2. Conext MPPT solar charge controller (When operating)
3. Conext XW Pro
When the Conext XW Pro is reporting, there are five battery states from empty to full.
When the available battery state is empty, no LEDs are lit. The battery is considered
empty when its depth of discharge exceeds approximately 50 per cent. When the battery
capacity is low, the two leftmost LEDs are lit. When the battery is at medium capacity,
the four leftmost LEDs are lit. When the battery capacity is full, all five LEDs are lit.
When the Conext Battery Monitor or Conext MPPT solar charge controller devices are
reporting, the true SOC will be indicated on the battery level LEDs and all LEDs will be
utilized.
NOTE: The battery LEDs are not a precise indicator of battery level. They are to be
considered a general guideline rather than an exact measurement. For greatest
accuracy, install the Conext Battery Monitor (Part # 865-1080-01) or refer to the
external BMS readings, if installed.
Figure 11 Battery Level LEDs
Conext XW Pro Owner's Guide Monitoring Operation
40 This document is intended for use by qualified personnel 990-91227A-01