Conext XW PRO 6848 6,800W 48V Installation
Table Of Contents
- Safety Information
- Label Symbols
- Product Labels
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Monitoring Operation
- External Monitoring Control
- Configuration
- Troubleshooting
- Specifications
- Electrical Specifications
- Mechanical Specifications
- Regulatory Approvals
- Grid Support Utility Interactive Functions
- California Rule 21: Smart Inverter Grid-Support Utility Interactive Functions
- Hawaiian Electric Company (HECO) Rule No. 14: Smart Inverter Grid-Support Uti...
- IEEE 1547-2003 Standard for Interconnecting Distributed Resources with Electr...
- Puerto Rico Energy Power Authority (PREPA) Technical Requirements for Interco...
- Defaults
Figure 12Status page
Status Displayed when...
Inverting
The Conext XW Pro is supplying power to loads on AC OUT by inverting power
from the batteries. AC input from the utility (AC1) or generator (AC2) is absent or
out of nominal range.
AC Pass-
through
The AC connected to the AC1 or AC2 input is passing directly through the
Conext XW Pro to the loads attached to AC Out. The batteries are not being
charged or discharged in this state.
APS only
Battery power is being consumed to power the control circuitry only. During grid
outages, the inverter is disabled. To enable the inverter for grid-forming, refer to
the Controls submenu in the Configuration menu.
Inverter
Disabled
Inverter is disabled or the unit has been placed in standby mode using the
Conext Gateway web application or the Standby key press
(STARTUP/SHUTDOWN and Equalization) on the inverter information panel. To
enable the inverter, see "Configuration" on page51.
Inverter
Fault
The Conext XW Pro has an active fault.
Grid
Support
There is AC input from the utility grid on AC1, however the priority for the Conext
XW Pro is to supply energy converted from external DC sources to the critical
loads on AC Out.
The Conext XW Pro enters this state only when Grid Support is set to ON and
battery voltage is above the Grid Support Voltage or SOC setting.
Table 2 Status page inverter states
Conext XW Pro Owner's Guide Monitoring Operation
42 This document is intended for use by qualified personnel 990-91227A-01