Conext XW PRO 6848 6,800W 48V Installation
Table Of Contents
- Safety Information
- Label Symbols
- Product Labels
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Monitoring Operation
- External Monitoring Control
- Configuration
- Troubleshooting
- Specifications
- Electrical Specifications
- Mechanical Specifications
- Regulatory Approvals
- Grid Support Utility Interactive Functions
- California Rule 21: Smart Inverter Grid-Support Utility Interactive Functions
- Hawaiian Electric Company (HECO) Rule No. 14: Smart Inverter Grid-Support Uti...
- IEEE 1547-2003 Standard for Interconnecting Distributed Resources with Electr...
- Puerto Rico Energy Power Authority (PREPA) Technical Requirements for Interco...
- Defaults
Header 1 Header 2
Absorption
Exit Pending
The Conext XW Pro has completed the absorption stage and is waiting for
other Conext XW Pro units in the system to complete absorption. This status
can occur only when there is another Conext XW Pro also charging the
battery.
Bulk
The Conext XW Pro is bulk charging the batteries from qualified AC input
from the utility grid (AC1) or a generator (AC2). AC input is also passed
through to the load while bulk charging.
Absorption
The Conext XW Pro is absorption charging the batteries from qualified AC
input from the utility grid (AC1) or a generator (AC2). AC input is also passed
through to the load while absorption charging.
Equalize
Equalization has been turned on and the Conext XW Pro is equalizing the
batteries after completing a full charge cycle.
Float
The Conext XW Pro is float charging the batteries from qualified AC input
from the utility grid (AC1) or a generator (AC2). The Conext XW Pro is set for
three-stage charging. AC input is also passed through to the load while float
charging.
Constant
Voltage and
Current
Charging state when External BMS is selected for Charge Cycle.
Charger
Disabled
Charging functionality is disabled. To enable this, refer to "Configuration" on
page51.
Qualifying
AC
The Conext XW Pro is determining if AC input on AC1 or AC2 is within a
usable voltage and frequency range. Qualifying AC is also displayed when
the Conext XW Pro is awaiting application of AC power or a command to
enable invert mode.
Qualifying
APS
The Conext XW Pro is undergoing a self-test to ensure the power to the
control circuitry (Auxiliary Power Supply) is adequate for use.
AC Good
The unit has qualified the input at AC1 or AC2 as within a usable voltage
and frequency range.
APS Good The unit has qualified the Auxiliary Power Supply.
AC Fault
The unit has encountered a fault. The fault description is displayed in the
Status or Events menus along with suggested remedies. To clear the fault,
refer to the Controls submenu in the Configuration menu.
Charge
The Conext XW Pro is charging the batteries from qualified AC input from the
utility grid (AC1) or a generator (AC2). The charge state is in transition to
either bulk, absorption, float, or equalize. AC input is also passed through to
the load while charging.
Ground Fault A ground fault has been detected by the system.
Table 3Status page charger states
Conext XW Pro Owner's Guide Monitoring Operation
44 This document is intended for use by qualified personnel 990-91227A-01