Conext XW PRO 6848 6,800W 48V Installation

Certain types of loads can cause search mode to work improperly. These types of loads
are described in "Problem Loads" on page103. If these kinds of loads are in the system,
follow the suggestions given to resolve the problem.
If the problem loads cannot be resolved, there are two workaround solutions:
Disable search mode from the main Conext XW Pro Setup menu, causing the inverter to
remain at full output voltage.
Use a search friendly companion load whose only purpose is to be switched on to wake
up the inverter to power the load that is unable to bring the inverter out of search mode.
NOTE: Search mode, by function, cannot work with clocks and timers or devices that
need power 24 hours a day. Examples of devices with timers include video recorders,
coffee makers with brew timers, refrigerators, and freezers with defrost timers.
Examples of devices that need power 24 hours a day include telephone answering
machines, alarm systems, motion detection lights, and some thermostats.
When the inverter is searching the output for loads, lights that have a wattage lower than
this setting may flash momentarily.
Charger Settings
WARNING
ADVANCED CONFIGURATION HAZARD
n Advanced menu settings should be used by qualified personnel only.
n Three phase operation should be configured by qualified personnel only.
n Consult with the local utility before enabling Conext XW Pro sell mode or grid support
functions.
n Do not change these settings unless you are under the supervision and direction of
qualified personnel.
n Connect the Conext Gateway and the network router connected to the Conext Gateway
to an assured power source during configuration.
Failure to follow these instructions can result in death, serious injury, or equipment
damage.
Configuration Conext XW Pro Owner's Guide
990-91227A-01 This document is intended for use by qualified personnel 59