Conext XW PRO 6848 6,800W 48V Installation
Table Of Contents
- Safety Information
- Label Symbols
- Product Labels
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Monitoring Operation
- External Monitoring Control
- Configuration
- Troubleshooting
- Specifications
- Electrical Specifications
- Mechanical Specifications
- Regulatory Approvals
- Grid Support Utility Interactive Functions
- California Rule 21: Smart Inverter Grid-Support Utility Interactive Functions
- Hawaiian Electric Company (HECO) Rule No. 14: Smart Inverter Grid-Support Uti...
- IEEE 1547-2003 Standard for Interconnecting Distributed Resources with Electr...
- Puerto Rico Energy Power Authority (PREPA) Technical Requirements for Interco...
- Defaults
Item Description
Bulk Termination
Voltage
Sets the voltage at or above which the Conext XW Pro begins the
timer to exit the bulk charging stage.
Bulk Termination
Time
Sets the time delay to exit the bulk charging stage once the bulk
termination voltage has been reached or exceeded.
Absorption Period
Timeout
Sets the time period that the Conext XW Pro will remain in the
absorption charge stage
Recharge SOC
Sets the SOC at or under which the Conext XW Pro will terminate
any discharging activity and begin to charge the battery if a qualified
AC source is available. Takes effect only when State of Charge
Control is enabled..
Recharge SOC
Delay
Sets the time delay after which the Conext XW Pro will begin to
charge the battery when SOC falls below the Recharge SOC, if a
qualified AC source is available.
EPC Max Charge
Power
Maximum charge power controllable via external interface.
For default settings, see "Charger Settings Menu" on page185.
Battery Charger Functions
When AC power is available, the Conext XW Pro can operate as a battery charger.
Different battery types and chemistries require different charging voltage levels. Not
charging batteries at the required levels can shorten battery life or damage the batteries.
The Conext XW Pro is configured at the factory to work with the battery types
recommended for inverter applications. If the default settings do not work for your
specific installation, you can adjust the charge stage settings (as recommended by the
battery manufacturer) by setting the Battery Type to Custom.
NOTE: This information is provided for guidance only. Variations in battery chemistry and
site-specific environmental considerations mean that you should consult your system
designer or battery manufacturer for specific recommendations for appropriate battery
voltage and current settings.
Battery Monitoring
The following table illustrates how to configure the Conext XW Pro for the available
battery monitoring methods.
Configuration Conext XW Pro Owner's Guide
990-91227A-01 This document is intended for use by qualified personnel 63