Conext XW PRO 6848 6,800W 48V Installation

Load Shave Amps
The load current above which Peak Load Shaving
activates and begins to supplement the power drawn
from the grid.
Load Shave Start
The time of day from which Peak Load Shaving is
permitted to operate.
Load Shave Stop
The time of day when Peak Load Shaving is no longer
permitted to operate.
Sell Block Start
The time of day from which the selling of power to the
grid is permitted.
AC PV Charge SoC
The SoC upper limit during grid forming when AC
coupled PV inverters are equipped. Below this level,
excess power from the PV inverters would charge the
battery. As the actual SoC approaches this level, the
Conext XW Pro will shift the grid forming frequency to
moderate the PV inverter output power as to prevent
further charging of the battery. Takes effect when State
of Charge Control is disabled
Sell Block End
The time of day when the selling of power to the grid is
no longer permitted.
State of Charge Control
Enable if equipped with a Conext Battery Monitor or an
external BMS (Eg. With lithium-ion batteries) to utilize
State of Charge to control mode transitions instead of
battery voltage.
Grid Support SoC
The SoC threshold above which grid support features
are enabled. This threshold takes effect when State of
Charge Control is disabled
Grid Support SoC Exit
Delay
Sets a delay period between when SoC falls below the
Grid Support threshold and when grid support
functions cease.
EPC Maximum Discharge
Power
Maximum battery discharge power available to an
external power controller.
For default settings, see "Grid Support Menu" on page187.
Conext XW Pro Owner's Guide Configuration
76 This document is intended for use by qualified personnel 990-91227A-01