Conext XW PRO 6848 6,800W 48V Installation

Item Description
Generator
Support Plus
When Generator Support Plus is enabled, the Conext XW
Pro will connect the center of its transformer to the AC2 input
neutral to act as a load balancing transformer. This feature will
attempt to balance the load between L1 and L2. See "Generator
Support Settings" on page78 for more details..
AC Coupling
AC Coupling function is enabled by default (Advanced
Features Menu) and should remain enabled except in cases
where the DC voltage level is allowed to have large variations
and the AC line frequency needs to remain constant.
Battery Energy
Balance
The Battery Energy Balance function is disabled by default
and is intended for use with inverters drawing power from a
single battery bank. The Battery Energy Balance function
should be enabled when Conext XW Pro units are used in
multi-unit systems with multiple battery banks. When enabled
this feature helps balance the power draw across multiple
battery banks.
Peak Load
Shaving Delay
When enabled, Peak Load Shaving mode is delayed by 2
hours to allow the MPPT solar charge controller to charge the
battery bank first, then when the timer of 2 hours expires, the
unit enters Peak Load Shaving mode for AC load support.
External
Transfer
Contactor
Enable if an external transfer contactor between the grid point
of connection and the Inverter-Chargers is present. Refer to the
Conext XW Pro Multi-unit Power System Design Guide
(document number 990-91373) for an overview guide. Refer to
"Multi-Unit Configuration Menu" on page83 for additional
configuration settings required in a multi-unit set up involving
an external contactor.
External Load
Switch
Enable if an external load/transfer switch is present. Refer to the
Conext XW Pro Multi-unit Power System Design Guide
(document number 990-91373) for an overview guide.
For default settings, see "Advanced Features Menu" on page191.
Conext XW Pro Owner's Guide Configuration
88 This document is intended for use by qualified personnel 990-91227A-01