Installation Manual

Materials List
975-0639-01-01 Rev D 1–5
This guide for use by qualified personnel only
Conext SW AC/DC/Ports Side Panel
Figure 1-4 AC and DC Terminals, Network and Communication Ports Panel
1
2
3
4
5
7
8
9
6
ab
Item Description
1 Battery Positive (+) (red) DC terminal connects to the positive bus bar
of the DC Switchgear.
2 Battery Negative (–) (black) DC terminal connects to the negative bus
bar of the DC Switchgear.
3XANBUS interface ports are used to connect Xanbus-enabled devices
including the optional SCP and AGS.
4STACKING port. Feature not available in this model.
5 Remote (REM) port provides connection for the on/off remote switch.
6 Battery temperature sensor (BTS) port provides connection for the
battery temperature sensor (supplied).
7 AC input/output lines wiring compartment access panel without the
compartment cover.
(a) AC Input terminal block is a screw-type terminal block for attaching
AC input wires. The terminals are labeled INPUT N for Neutral and
INPUT L1 and L2 for split-phase lines 1 and 2 respectively.
(b) AC Output terminal block is a screw-type terminal block for
attaching AC output wires. The terminals are labeled OUTPUT N for
Neutral and OUTPUT L1 and L2 for split-phase lines 1 and 2
respectively.
8 All
 Ground terminals are along the tab (as shown) of the AC wiring
compartment access panel opening.
9 AC knockouts (3/4" and 1") provide access for AC cables (both input
and output wiring). Detach the knockout covers and install strain-relief
clamps available in hardware and electrical stores.
Not
shown
AC wiring compartment cover that is taken out during wiring and put
back in when wiring has been completed.
ConextSW-NA-InstallationGuide.book Page 5 Tuesday, July 21, 2015 4:39 PM