Installation Manual
Installation
1–6 975-0639-01-01 Rev D
This guide for use by qualified personnel only
Conext SW Supplied Accessories
NOTE: If any of the supplied accessories are missing, contact customer service
for replacement. See “Contact Information solar.schneider-electric.com” on
page ii.
Figure 1-5 Supplied Accessories
2
1
3
Item Description
1 BTS, the Battery Temperature Sensor consists of:
• Connector that plugs into the BTS port on the Conext SW.
• Sensor cable is 25 feet (7.6 meters).
• Sensor can be mounted on the side of the battery case or on
the negative battery terminal.
NOTE: The BTS continuously measures the temperature of the battery
and adjusts the charger output for a more accurate, temperature-
compensated charge.
2 Two sets of M6 nuts and washers are used to secure the DC
Switchgear’s bus bars to the DC battery terminals.
3 Two Xanbus network terminators are used to properly terminate each of
the two ends of the daisy-chained Xanbus network. For example, if the
SCP is connected to the inverter/charger, one terminator will be
plugged to the SCP, one network cable will connect both devices, and
one terminator will be plugged to the inverter/charger.
IMPORTANT: The SCP may perform erratically if the Xanbus network is
not properly terminated.
4 Two DC terminal covers (not shown) - not needed for installation with
the DC Switchgear which is required in Canada and the USA.
5 Installation bracket (not shown)
ConextSW-NA-InstallationGuide.book Page 6 Tuesday, July 21, 2015 4:39 PM