Installation Manual

Installation Planning
975-0639-01-01 Rev D 1–13
This guide for use by qualified personnel only
The illustration below shows which components you may need before you begin
your installation.
AC Wiring Definition AC wiring includes input wiring (all the wires and connectors
between the main AC source panel and the inverter/charger AC INPUT) and
output wiring (all the wires between the inverter/charger AC OUTPUT and the AC
load panels, circuit breakers, and loads).
Typ e The type of wiring required varies according to the electrical codes or
regulations applicable to your installation. Wiring may be solid in multi-conductor
cables, but stranded wire is required if single conductors are used. All wiring
must be rated 90 °C or higher.
Figure 1-9 AC, DC, and Network Components
• 24- or 48-volt battery or batteries, see “DC
Component -Batteries” on page 1–14.
• DC-rated fuse and/or circuit breaker,
see “DC Disconnects and Overcurrent
Devices” on page 1–15.
• Conext SW DC Switchgear (required
component in Canada and USA)
• Battery Temperature Sensor
(BTS, supplied)
• DC cables, see “DC
Cabling” on page 1–14.
• solar panel for renewable
energy application
120/240-volt split-phase, 60 Hz
AC Loads (AC OUTPUT)
DC Components Xanbus Network Components
• Main electrical distribution
panel (grid and/or generator)
• AC-rated 30-amp circuit
breakers to provide overcurrent
protection and means of disconnect
• Transfer switch (between two AC
sources, if applicable)
• Conext SW AC Switchgear
(recommended)
• AC cable (4-wire) and connectors, see
“AC Wiring” on page 1–13.
• Inverter electrical
distribution panel
• AC-rated 30-amp circuit
breakers to provide overcurrent
protection and means of disconnect
• Conext SW AC Switchgear
(recommended)
• AC cable (4-wire) and connectors, see
“AC Wiring” on page 1–13.
• System Control Panel (SCP)
• Automatic Generator Start (AGS)
• Battery Monitor
• Solar charge controller
• Conext ComBox
• CAT-5 network cables
• Xanbus network terminators
(supplied)
120/240-volt split-phase, 60 Hz
AC Source (AC INPUT)
ConextSW-NA-InstallationGuide.book Page 13 Tuesday, July 21, 2015 4:39 PM