Installation Manual

Installation
1–20 975-0639-01-01 Rev D
This guide for use by qualified personnel only
Figure 1-10 Conext SW Mounting Instructions
5 7/8 in.
149.0 mm
(1) Place the
installation bracket flat
on the wall (or
plywood) and mark the
positions of the
mounting holes on the
wall.
(2) Pilot drill the four
mounting holes on wall
studs (or plywood).
(3) Fasten the
installation bracket to
the mounting surface
with four #12 (or
equivalent) screws.
(4) With two people,
hang the Conext SW to
the installation bracket
carefully aligning the
Conext SW’s mounting
holes to the threaded
bolts on the installation
bracket.
(5) Secure the Conext
SW to the installation
bracket using the
supplied M6 nuts.
TIP: Align the mounting holes in the center of wall studs. If necessary, fasten a plywood board first to a wall
with non-standard-spaced wall studs. Then mount the inverter/charger on the plywood board.
16-inch
standard-
spaced wall
studs.
(2)
TIP: Use these
mounting holes for
concrete walls or
other solid walls.
ConextSW-NA-InstallationGuide.book Page 20 Tuesday, July 21, 2015 4:39 PM