Installation Manual

Inverter/Charger Installation
975-0639-01-01 Rev D 1–21
This guide for use by qualified personnel only
Step 3: Connecting the AC Input and AC Output Wires
General AC Wiring Considerations
AC and DC Wiring Separation Do not mix AC and DC wiring in the same
conduit or panel. Consult the applicable installation code for details.
AC Knockouts There are two dual 3/4" /1" trade-size knockouts on the side
panel and another two on the bottom panel for AC wiring. Use the same trade
size of strain relief as the trade size of the knockout(s) you are using.
AC Wiring Terminals The AC wiring terminals accept cables of a specific size.
See “AC Wiring” on page 1–13 for required sizes.
DANGER
ELECTRICAL SHOCK AND FIRE HAZARD
Make sure wiring being connected to the inverter/charger is disconnected
(physically or by opening and locking out the breaker) from all electrical
sources before handling. All wiring must be done in accordance with local and
national electrical wiring codes.
Failure to follow these instructions will result in death or serious injury.
NOTICE
EQUIPMENT DAMAGE
Do not mix input and output wires. The terminal block is split into INPUT and
OUTPUT sections. Damage may occur if the unit is wired incorrectly.
Failure to follow these instructions can damage the inverter/charger.
WARNING
ELECTRICAL SHOCK AND FIRE HAZARD
Turn off all electrical sources (by opening and locking out main and inverter
panel breakers) before connecting wires to and from the inverter/charger. All
wiring must be done in accordance with local and national electrical wiring
codes.
Failure to follow these instructions can result in death or serious injury.
ConextSW-NA-InstallationGuide.book Page 21 Tuesday, July 21, 2015 4:39 PM