Conext SW4048 4,000W 48V Installation
Table Of Contents
- Conextâ„¢ SW Inverter/Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-03 Revision: Date: 5-2020
- Contact Information solar.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Safety Information
- Precautions When Working With Batteries
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Basic Protection Features
- Grid-interactive and Other Features
- Load Shaving
- AC Support
- Grid-Interactive Delay Feature
- AC Coupling
- AC Couple Smart Charge
- Storing the State of the Inverter Mode
- NoLoadVD
- Low Battery Cut Out Hysteresis
- LBCO Delay
- Lithium Ion Battery Type
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- AC Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Advanced Features Menu
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
System Components
975-0638-01-03 2–3
For detailed instructions and a complete list of Xanbus-enabled devices, visit
www.schneider-electric.com.
Xanbus-enabled Products and Other Accessories
Product/Accessory (Shown above) Product Number/s
1 Conext SW DC Switch Gear* 865-1016*
2 Conext SW AC Switch Gear 865-1017
3 MPPT 60 150 Solar Charge Controller 865-1030-1
MPPT 80 600 Solar Charge Controller (not shown) 865-1032
4 Conext SW On/Off Remote Switch (not shown) 865-1052
5 System Control Panel (SCP) 865-1050
6 Conext CM (not shown) 865-1058
7 Automatic Generator Start (AGS) 865-1060
8 Conext Battery Monitor 865-1080-01
9 Battery Temperature Sensor (BTS) 808-0232-02
10 3-ft network cable (0.9 m) 809-0935
25-ft network cable (7.6 m) 809-0940
75-ft network cable (22.9 m) 809-0942
*
required accessory for code-compliant installation in Canada and USA.
/
7.6 m cable 22.9 m cable0.9 m cable
3
1
2
5
7
9
10
6
8