Conext SW4048 4,000W 48V Installation
Table Of Contents
- Conext™ SW Inverter/Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-03 Revision: Date: 5-2020
- Contact Information solar.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Safety Information
- Precautions When Working With Batteries
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Basic Protection Features
- Grid-interactive and Other Features
- Load Shaving
- AC Support
- Grid-Interactive Delay Feature
- AC Coupling
- AC Couple Smart Charge
- Storing the State of the Inverter Mode
- NoLoadVD
- Low Battery Cut Out Hysteresis
- LBCO Delay
- Lithium Ion Battery Type
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- AC Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Advanced Features Menu
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
Operation
3–2 975-0638-01-03
Start Up Behavior
When the Conext SW is powered up (energized) or has been reset (using the
Reset button on the front panel), all of the front panel LEDs illuminate and remain
on for a minimum of five seconds. During this interval, the fans also turn on as the
unit executes internal diagnostics.
The Conext SW inverter function is initially disabled (meaning the unit will not
invert even if there is sufficient battery voltage) every time the Conext SW is
energized for the first time. After being energized, the Inv Enable button on the
front panel can be used to enable or disable the inverter. A separate control
device called a System Control Panel (or SCP) may also be used to enable or
disable the inverter. However, the unit will remember its inverter function setting in
succeeding operations. This means that if the inverter function is left enabled
before a reset or power down-power up cycle, the inverter function will remain
enabled.
When a function is enabled, it generally means that it is “standing by” and other
conditions may have to be met before the function is utilized. For example, the
charger function on the Conext SW may be enabled, but it will not charge unless
qualified AC power is present. Similarly, even if the inverter function is enabled,
inverting may not occur if the batteries cannot supply the energy required for the
loads.
IMPORTANT: Review the “Important Safety Instructions” on page v before
operating the inverter/charger.