Conext SW4048 4,000W 48V Installation
Table Of Contents
- Conext™ SW Inverter/Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-03 Revision: Date: 5-2020
- Contact Information solar.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Safety Information
- Precautions When Working With Batteries
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Basic Protection Features
- Grid-interactive and Other Features
- Load Shaving
- AC Support
- Grid-Interactive Delay Feature
- AC Coupling
- AC Couple Smart Charge
- Storing the State of the Inverter Mode
- NoLoadVD
- Low Battery Cut Out Hysteresis
- LBCO Delay
- Lithium Ion Battery Type
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- AC Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Advanced Features Menu
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
About This Guide
iv 975-0638-01-03
Abbreviations, Acronyms, and Symbols
Related Information
You can find more information about Schneider Electric as well as its products
and services at solar.schneider-electric.com.
AC Alternating Current LED Light Emitting Diode
AGS Automatic Generator Start SCP System Control Panel
BOS Balance of System SW Sine Wave
DC Direct Current VAC Volts, Alternating Current
PPE Personal Protective
Equipment
VDC Volts, Direct Current
PV Photovoltaic IP20 Ingress protection rating
Reference to see guide
(or manual) for more
information
Ground
AC DC
Denotes a steady LED Denotes a flashing LED
Inv Enabled – see “Front
Panel LEDs” on page 3–4
for definition.
Gen Support – see “Front
Panel LEDs” on page 3–4
for definition.
AC IN – see “Front Panel
LEDs” on page 3–4 for
definition
.
Charging – see “Front
Panel LEDs” on page 3–4
for definition.
Fault – see “Front Panel
LEDs” on page 3–4 for
definition.
Warning – see “Front
Panel LEDs” on page 3–4
for definition.
Clear Fault | Reset – see
“Conext SW Front and
Side Panels” on page 2–4
for definition.
Inv Enable – see “Conext
SW Front and Side
Panels” on page 2–4 for
definition.