Conext SW4048 4,000W 48V Installation
Table Of Contents
- Conextâ„¢ SW Inverter/Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-03 Revision: Date: 5-2020
- Contact Information solar.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Safety Information
- Precautions When Working With Batteries
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Basic Protection Features
- Grid-interactive and Other Features
- Load Shaving
- AC Support
- Grid-Interactive Delay Feature
- AC Coupling
- AC Couple Smart Charge
- Storing the State of the Inverter Mode
- NoLoadVD
- Low Battery Cut Out Hysteresis
- LBCO Delay
- Lithium Ion Battery Type
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- AC Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Advanced Features Menu
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
Operation
3–18 975-0638-01-03
To change an operational setting
1. From the device Setup menu screen, use the up or down arrow buttons to
highlight any operational setting you wish to change.
2. Press Enter then use the up or down arrow buttons to move between
selections. For example, the inverter setting can be changed to either
Enabled or Disabled.
3. Press Enter to confirm the selection.
4. Press Exit (twice) to go back to the System Status menu screen.
To clear fault detections/warnings:
1. From the device Setup menu screen, use the up or down arrow buttons to
highlight Clear Faults/Warnings.
2. Press Enter to clear the highlighted selection.
Figure 3-8 Conext SW Setup Menu Operational Settings
CSW4024 00: Setup
Meters
Inverter
Search Mode
Charger
Force Chg State
Equalize
Mode
Clear Faults/Warnings
View Device Info
Basic Settings
[Enabled]
[Disabled]
[Enabled]
[Bulk]
[Disabled]
[Operating]
[*Enabled] [Disabled]
[*Enabled] [Disabled]
[*Enabled] [Disabled]
[*Bulk] [Float] [NoFloat]
[*Enabled] [Disabled]
[*Operating] [Standby]