Conext SW4048 4,000W 48V Installation
Table Of Contents
- Conext™ SW Inverter/Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-03 Revision: Date: 5-2020
- Contact Information solar.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Safety Information
- Precautions When Working With Batteries
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Basic Protection Features
- Grid-interactive and Other Features
- Load Shaving
- AC Support
- Grid-Interactive Delay Feature
- AC Coupling
- AC Couple Smart Charge
- Storing the State of the Inverter Mode
- NoLoadVD
- Low Battery Cut Out Hysteresis
- LBCO Delay
- Lithium Ion Battery Type
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- AC Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Advanced Features Menu
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
Configuring Advanced Settings
975-0638-01-03 4–21
NOTE: If a warning is received indicating that a setting is not accepted by the
SCP, gradually increase the value of the setting until the SCP accepts it. This
type of warning means that an internal minimum threshold value is being crossed
and therefore the setting cannot be saved.
Table 4-12 Custom Battery Settings Menu Description
Setting Description
Eqlz Support Enables or disables the ability to enter an equalization cycle.
Refer to the battery manufacturer’s specifications to determine
whether equalization is recommended.
Eqlz
Voltage
a
a.The Eqlz Voltage setting is displayed when Eqlz Support is set to Enabled.
Selects the equalization voltage. Consult your battery
manufacturer for equalization voltage setting.
Bulk Voltage Sets the bulk voltage for a custom battery type. This setting
must be 0.8 V or more for the 48-volt model (or 0.4 or more for
the 24-volt models) than the Bulk Termination Voltage. See note
below.
Bulk
Termination
Voltage
Sets the bulk termination voltage for a custom battery type.
This setting must be 0.8 V or less for the 48-volt model (or 0.4
or less for the 24-volt models) than the Bulk Voltage. See note
below.
Absorb
Voltage
Sets the absorption voltage for a custom battery type.
Float
Voltage
Sets the float voltage for a custom battery type. See note
below.
Batt Temp
Comp
Battery temperature compensation for a custom battery type.
This setting is the reference that the BTS uses to adjust the
charging voltage when the temperature is above or below
77 °F (25 °C).