Conext SW4048 4,000W 48V Installation

Configuration via SCP
4–38 975-0638-01-03
Configuration Sheet
SETTING DESCRIPTION
DEFAULT
24-volt
DEFAULT
48-volt
YOUR
SETTING
Inverter
Settings
Low Batt Cut Out Select battery voltage below which batteries will be cut out 21.0V 42.0V
LBCO Delay
Select the time delay before low battery cut out is engaged 10sec 10sec
Hi Batt Cut Out
Select the voltage above which batteries will be cut out 29.0V 58.0V
Search Watts
Select Watts at which level Search Mode triggers on 50W 50W
Search Delay
Select delay time before Search Mode triggers on 2sec 2sec
Inv Block Start
Sets the time to halt inverting 12:00AM 12:00AM
Inv Block Stop
Sets the time to resume inverting 12:00AM 12:00AM
Charger
Settings
Batt Type
Select your battery type (FLOODED, GEL, AGM, Custom) Flooded Flooded
Custom Settings
Makes BATTERY CUSTOM SETTINGS screen visible -- --
Eqlz Support Enable battery EQUALIZE function Enabled Enabled
Eqlz Voltage Select maximum EQUALIZE voltage 32.0V 62.0V
Bulk Voltage Select maximum BULK charge voltage 28.8V 57.6V
Bulk Termination
Voltage
Select maximum BULK TERMINATION charge voltage 28.4V 56.8V
Absorb Voltage Select maximum ABSORPTION charge voltage 28.8V 57.6V
Float Voltage Select maximum FLOAT charge voltage 27.0V 54.0V
Batt Temp Comp Select BATTERY TEMPERATURE COMP coefficient -54mV/C -108mV/C
Batt Capacity Select battery bank capacity 250Ah 250Ah
Max Chg Rate
Select maximum charge rate 100% 100%
Charge Cycle
Select 2 or 3 stage charge cycle 3Stage 3Stage
Default Batt Temp
Select system default battery temp setting Warm Warm
ReCharge Volts
Select voltage at which charger will initiate a charge cycle 25.0V 50.0V
Absorb Time
Sets the maximum Absorption time 180min 180min
Auto Chg Enable
Select automatic charging, overrides Charger setup Disabled Disabled
Chg Block Start
Sets the time to halt charging 12:00AM 12:00AM
Chg Block Stop
Sets the time to resume charging 12:00AM 12:00AM
AC
Settings
AC Breaker
Select AC Input current limit 30A 30A
AC Lo Volt
Select lowest acceptable AC voltage 95V 95V
AC Hi Volt
Select highest acceptable AC voltage 135V 135V
AC Lo Freq
Select lowest acceptable AC frequency 55Hz 55Hz
AC Hi Freq
Select highest acceptable AC frequency 65Hz 65Hz
AC
Support
AC Supp Mode
Sets the AC Support feature Enabled Enabled
AC Supp Volts
Sets the AC support voltage 26.5V 53.0V
Load Shave
Sets the load shaving feature Disabled Disabled
Load Shave Amps
Sets the current for load shaving 24A 24A
Load Shave Start
Sets the start time for load shaving 12:00AM 12:00AM
Load Shave Stop
Sets the stop time for load shaving 12:00AM 12:00AM
AC Supp on Soc
Sets the AC Support feature based on SOC Enabled Enabled
AC Supp Start Soc
Sets the start time for SOC AC support 80% 80%
AC Supp Stop Soc
Sets the stop time for SOC AC support 50% 50%