Conext SW4048 4,000W 48V Installation
Table Of Contents
- Conext™ SW Inverter/Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-03 Revision: Date: 5-2020
- Contact Information solar.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Safety Information
- Precautions When Working With Batteries
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Basic Protection Features
- Grid-interactive and Other Features
- Load Shaving
- AC Support
- Grid-Interactive Delay Feature
- AC Coupling
- AC Couple Smart Charge
- Storing the State of the Inverter Mode
- NoLoadVD
- Low Battery Cut Out Hysteresis
- LBCO Delay
- Lithium Ion Battery Type
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- AC Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Advanced Features Menu
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
Configuration Sheet
975-0638-01-03 4–39
Multi
Unit
Config
Dev Name
Select unique device Name for each unit
CSW4024
CSW2524
CSW4048
Dev Number
Select unique device number for each unit
00 00
Invtr Mode
Do not use at this time
Master Master
AC In
Select AC source type
Gen1 Gen1
Battery
Identify batteries
HouseBatt1 HouseBatt1
Restore
Defaults
Restore Defaults
Restores all system default settings
-- --
Advanced
Features
EuroFreq
Sets AC output frequency to 50 Hertz
Disabled Disabled
StoreInv
State
Sets inverter mode state feature.
Enabled Enabled
AcCouple
Sets AC Coupling feature. See “AC Coupling” on page 1–12.
Disabled Disabled
Enhanced ACSup
Sets enhanced AC Support feature. See “Enhanced AC
Support” on page 1–9.
Disabled Disabled
PLSDelay
Sets load shaving delay for 2 hours. See “Grid-Interactive
Delay Feature” on page 1–11.
Disabled Disabled
NoLoadVD
Sets no load voltage derating feature. See “NoLoadVD” on
page 1–15.
Disabled Disabled
SETTING DESCRIPTION
DEFAULT
24-volt
DEFAULT
48-volt
YOUR
SETTING