Installation Manual

Wiring the Conext XW+ Inverter/Charger without a PDP
975-0239-01-01 Rev J 3–65
This manual is for use by qualified personnel only
This section provides illustrations for wiring the AC and DC connections for a
Conext XW+ without a Conext XW+ Power Distribution Panel.
Pre-Installation Steps
Depending on your installation, you will need to perform some or all of some the
following pre-installation steps:
1. Prepare the battery bank. See “Battery Bank Preparation” on page 2–13.
2. Wall-mount the Conext XW+ Inverter/Chargers. See “Wall-Mounting the
Conext XW+ and PDP” on page 2–9.
3. Install Conext XW+ Conduit Box as needed. See “Installing the Conext XW+
Conduit Box” on page 2–10.
4. Install AC sync and Xanbus cable(s) as needed. See “Installing AC sync and
Xanbus cables” on page 4–5.
5. Remove knockouts on the Conext XW+ as needed to accommodate the
wiring. See “Knockout Selection” on page 2–4 for more information about
knockouts.
Feed-in Protection Requirements
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Battery Circuit Breakers must be installed according to the specifications
and requirements defined by Schneider Electric.
• Servicing of batteries must only be performed by qualified personnel
knowledgeable of batteries and the required precautions. Keep unqualified
personnel away from batteries.
• Disconnect the charging source prior to connecting or disconnecting battery
terminals.
Failure to follow these instructions will result in death or serious injury.
NOTICE
OVERLOADING THE DISTRIBUTION PANEL
The amount of power that can be fed into a distribution panel and the means
and location for feed-in, must be in accordance with NEC 2008 article 690.64
or the current requirements of the local electrical code.
Failure to follow these instructions can result in damage to equipment.
XW-NA-Install.book Page 65 Wednesday, August 12, 2015 2:23 PM