Installation Manual

Wiring the Conext XW+ Inverter/Charger without a PDP
975-0239-01-01 Rev J 3–67
This manual is for use by qualified personnel only
Figure 3-36 Grounding the DC System (No PDP)
AC INAC OU T AC IN
GRID
(AC1)
AC
LOAD
GEN
(AC2)
NL1L2NL1L2NL1 L2
1
2
3
1. AC Ground bar
2. Negative ground/bus
3. Vented battery enclosure
Actual wiring requirements may vary.
Cable routing may vary. See Knockout Selection
on page 2-5 and Communications Network
Preparation on page 2-12.
For torque values, see page 2-16 and 2-17.
LEGEND
XW-NA-Install.book Page 67 Wednesday, August 12, 2015 2:23 PM