Installation Manual

Wiring the Conext XW+ Inverter/Charger without a PDP
975-0239-01-01 Rev J 3–69
This manual is for use by qualified personnel only
Figure 3-38 Grounding the AC System (No PDP)
AC INAC OUT AC IN
GRID
(AC1)
AC
LOAD
GEN
(AC2)
NL1L2NL1L2NL1 L2
NG
L1 L2
4
1
3
5
L2
L1
2
1. To AC ground bar
2. To inverter load sub-panel
3. To main utility panel
4. Generator disconnect
Note: Depending on the location of the generator
and local code requirements, the generator
disconnect may be located in the power
distribution panel.
5. To AC generator
Grounding requirements may vary.
Cable routing may vary. See Knockout Selection
on page 2-5 and Communications Network
Preparation on page 2-12. For torque values, see
page 2-16 and 2-17.
LEGEND
XW-NA-Install.book Page 69 Wednesday, August 12, 2015 2:23 PM