Installation Manual

Xanbus Network Installation
4–6 975-0239-01-01 Rev J
This manual is for use by qualified personnel only
To install the AC sync and Xanbus cables:
1. Remove the two raceways for the communication cabling by removing the
screw holding each raceway in place, as shown in Figure 4-5.
2. Insert the RJ45 jack on the cable into one of the two AC Sync ports.
Figure 4-5 XW+ Conduit Box raceways
Raceway
Raceway
Raceway Raceway
screw screw
XW-NA-Install.book Page 6 Wednesday, August 12, 2015 2:23 PM