Installation Manual
Conext XW+ Inverter/Charger Accessories Installation
5–2 975-0239-01-01 Rev J
This manual is for use by qualified personnel only
Conext Combox Installation
The Conext XW+ Inverter/Charger can be controlled remotely by connecting a
Conext ComBox.
The Conext ComBox allows access to programming features of the Conext XW+
and allows the system to be modified to specific installation requirements.
For installation instructions, see the Conext Combox Owner’s Guide
(975-0679-01-01).
Conext System Control Panel Installation
The Conext XW+ can be controlled remotely by connecting a Conext System
Control Panel (SCP).
The SCP allows access to programming features of the Conext XW+ and allows
the system to be modified to specific installation requirements.
The SCP can be connected to the Conext XW+ Inverter/Charger through one of
the following two methods:
• via the Xanbus network (see “Installing the SCP via the Xanbus Network” on
page 5–3), or
• by replacing the inverter information panel with the SCP (see “Replacing the
Inverter Information Panel with the SCP” on page 5–4).
XW-NA-Install.book Page 2 Wednesday, August 12, 2015 2:23 PM