Installation Manual

Conext System Control Panel Installation
975-0239-01-01 Rev J 5–5
This manual is for use by qualified personnel only
1. If the AC access panel is attached to the Conext XW+ chassis, remove it (as
shown in “AC Access Panel Removal” on page 3–2).
2. Remove the four screws from the inverter information panel, as shown in
Figure 5-2.
3. Carefully remove the inverter information panel from the Conext XW+
chassis, and detach it from the inverter communication cable.
4. Remove the metal support plate from the housing of the Conext XW+
chassis.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Battery Circuit Breakers must be installed according to the specifications
and requirements defined by Schneider Electric.
• Servicing of batteries must only be performed by qualified personnel
knowledgeable of batteries and the required precautions. Keep unqualified
personnel away from batteries.
• Disconnect the charging source prior to connecting or disconnecting battery
terminals.
Failure to follow these instructions will result in death or serious injury.
Figure 5-2 Inverter information panel removal
Inverter communication cable
metal support plate
Inverter information panel
XW-NA-Install.book Page 5 Wednesday, August 12, 2015 2:23 PM