Installation Manual

Conext XW+ Inverter/Charger Accessories Installation
5–6 975-0239-01-01 Rev J
This manual is for use by qualified personnel only
5. For easier access, remove the right-side panel of the Conext XW+, as shown
in Figure 5-3.
6. Unplug the communication cable from the upper communication port
To install the SCP into the Conext XW+ chassis:
1. Plug the inverter communication cable into the lower communication port.
2. Re-secure the right-side panel (if applicable).
3. Carefully place the SCP into the housing of the Conext XW+ chassis.
Figure 5-3 Right-side panel removal
XW-NA-Install.book Page 6 Wednesday, August 12, 2015 2:23 PM