Installation Manual

This manual is for use by qualified personnel only
A Specifications
Appendix A, “Specifications” provides the
electrical and mechanical specifications for the
Conext XW+ Inverter/Charger.
DISCLAIMER REGARDING STATUS DATA
STATUS DATA REPORTED BY THE XW/XW+ INVERTER/CHARGER (THE “XW/XW+”) ARE
APPROXIMATE VALUES INTENDED TO PROVIDE GENERAL AND NON-EXACT
INFORMATION ABOUT THE XW/XW+ SYSTEM. UNDER NO CIRCUMSTANCES SHOULD
THIS STATUS DATA BE USED FOR PRECISE EVALUATION OF THE XW/XW+ AND/OR
SYSTEM PERFORMANCE, INCLUDING EFFICIENCY CONSIDERATIONS. IN SYSTEMS
WITH A SINGLE XW/XW+ UNIT, THE MEASUREMENT CAPABILITIES OF THE XW/XW+
ALLOW FOR DEVIATIONS OF UP TO 5% OF ACTUAL VALUES. IN SYSTEMS WITH
MULTIPLE XW/XW+ UNITS, THE COMPOUNDED EFFECT OF ACCURACY DEVIATIONS IN
THE STATUS DATA COULD RESULT IN AGGREGATED DEVIATIONS EXCEEDING 5% OF
ACTUAL VALUES. FOR SYSTEMS REQUIRING HIGHER ACCURACY STATUS REPORTING
OF AC PARAMETERS, SCHNEIDER ELECTRIC RECOMMENDS THE USE OF EXTERNAL
MONITORING EQUIPMENT OF APPROPRIATE AND ACCURATE CALIBRATION. FOR
HIGHER ACCURACY MEASUREMENT OF DC (BATTERY) PARAMETERS, SCHNEIDER
ELECTRIC RECOMMENDS INSTALLING AN APPROPRIATE DC BATTERY MONITOR IN THE
SYSTEM.
XW-NA-Install.book Page 1 Wednesday, August 12, 2015 2:23 PM