Installation Manual

Single-Inverter System (Backup Only) Without a Conext XW+ Power Distribution Panel
975-0239-01-01 Rev J B–3
This manual is for use by qualified personnel only
Single-Inverter System (Backup Only) Without a Conext XW+ Power Distribution Panel
Figure B-1 Single-Inverter System (Backup Only) Without a Conext XW+ Power Distribution Panel
1
2
3
4
5
6
7
8
6
9
NG
L1 L2
3
1
2
4
5
7
10
10
NL1L2NL1L2NL1 L2
AC IN
GRID
AC OUT
INV
OUT
AC IN
GEN
8 9
Standby
Event/Warning
Conext XW SCP
L2L1
LEGEND
SCP (optional)
AGS (optional)
Main utility panel
Inverter load sub-panel
AC generator
Generator disconnect
Negative ground bus
Circuit breaker/
Fuse block (optional)
Battery bank
AC Sync cable
Ground
Xanbus cable
Hot L1
Hot L2
Neutral
Actual wiring requirements may vary.
Cable routing may vary.
See “Knockout Selection” on page 2–4 and “Communications Network Preparation” on page 2–12.
See “Torque Values” on page 2–16.
For torque connections to the battery terminals, consult the battery manufacturer’s recommendations.
DC disconnect
Positive (+)
battery terminal
Positive (+)
battery cable
Negative (-)
battery terminal
Negative (-)
battery cable
Appendix B - Wiring Diagrams_11x17.fm Page 3 Monday, July 13, 2015 12:37 PM