Installation Manual

Split-Phase to Single-Phase Conversion Instructions
C–4 975-0239-01-01 Rev J
This manual is for use by qualified personnel only
Disconnecting Power Sources
To disconnect power sources:
1. Put the Conext XW+ system in Standby mode using the System Settings
menu on the Conext System Control Panel, disconnect AC sources (such as
the utility grid and generators) by turning off the AC input breakers, and
disconnect DC sources (for example, batteries) by turning off the
DC breaker.
2. Turn off and disconnect all AC loads by turning off the AC output breaker.
XW-NA-Install.book Page 4 Wednesday, August 12, 2015 2:23 PM