Installation Manual

Split-Phase to Single-Phase Conversion Instructions
C–6 975-0239-01-01 Rev J
This manual is for use by qualified personnel only
To remove the AC access panel, remove the two screws from the AC access
cover and slide the cover slightly to the left and lift away from the Conext XW+
chassis.
Installation tip For easier access, first remove the right-side panel of the Conext XW+, as shown
in Figure 5-3 on page 5–6.
When re-securing the AC access cover, ensure its recessed edge slips inside the
edge of the front panel.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Battery Circuit Breakers must be installed according to the specifications
and requirements defined by Schneider Electric.
• Servicing of batteries must only be performed by qualified personnel
knowledgeable of batteries and the required precautions. Keep unqualified
personnel away from batteries.
• Disconnect the charging source prior to connecting or disconnecting battery
terminals.
Failure to follow these instructions will result in death or serious injury.
Figure C-2 AC access panel removal
(Internal components
hidden for clarity)
XW-NA-Install.book Page 6 Wednesday, August 12, 2015 2:23 PM