Installation Manual

Optional Accessories
975-0239-01-01 Rev J 1–5
This manual is for use by qualified personnel only
Optional Accessories
The following optional accessories are available for the Conext XW+ Inverter/
Charger.
For an up-to-date list, call an authorized dealer or visit
solar.schneider-electric.com.
Conext XW+ Conduit Box
Part Number
865-1025-01
The Conext XW+ Conduit Box provides an enclosure over the bottom of the
Conext XW+ and covers the cabling that runs underneath.
For installation instructions, see “Installing the Conext XW+ Conduit Box” on
page 2–10 of this Guide.
Conext XW+ Power Distribution Panel
Part Number
865-1015-01
The Conext XW+ Power Distribution Panel (PDP) is factory wired and labelled
with everything to support a single-inverter installation.
Internal wiring and breakers can be added to expand the Conext XW+ with up to
three inverters, four charge controllers, or other equipment to support 120/
240 volt, three-wire, single-phase systems.
The PDP interfaces with the following Conext products:
• Conext XW+ 5548 NA and Conext XW+ 6848 NA Inverter/Chargers
• Conext MPPT Solar Charge Controllers (breakers and wiring not included)
• C-Series Charge Controllers (breakers and wiring not included).
Figure 1-3 Conext XW+ Conduit Box
Note: Your installation may require the inclusion of the Conext XW+ Conduit Box,
depending on local electrical code. Consult your local electrical authority to
ensure your installation is code-compliant.
XW-NA-Install.book Page 5 Wednesday, August 12, 2015 2:23 PM