Installation Manual

Pre-Installation
975-0239-01-01 Rev J 2–5
This manual is for use by qualified personnel only
See Figure 2-2, below, for an example of available knockouts along the top and
side of the Conext XW+ Power Distribution Panel.
Remove your choice of knockouts from the Conext XW+ chassis, Conext XW+
Conduit Box, and/or Conext XW+ Power Distribution Panel. Ensure that no debris
remains inside the chassis. Insert appropriately-sized conduit bushings into each
conduit hole.
Air Filter and AUX Port Connector Installation
Insert the air filter by tucking it into the grooves on the sides of the air vent cover
(See Figure 2-3.)
If you are planning to use the auxiliary (AUX) port features, insert the AUX port
connector into the AUX port. (See Figure 2-3.)
Figure 2-2 Example of available knockouts on the PDP
XW-NA-Install.book Page 5 Wednesday, August 12, 2015 2:23 PM