Installation Manual

Pre-Installation and Wall-Mounting
2–6 975-0239-01-01 Rev J
This manual is for use by qualified personnel only
For more information, see “AUX Port” on page 3–5 of this Guide.
Wall-Mounting
A mounting plate is included with each Conext XW+ Inverter/Charger and Conext
XW+ Power Distribution Panel (PDP), designed to meet standards for structural
and seismic stability. When properly installed, the system also meets Section 59
of UL 1741 for Static Loads.
Figure 2-3 Air Filter and AUX Port Connector Installation
WARNING
HEAVY EQUIPMENT
The Conext XW+ Inverter/Charger can cause serious injury if it falls or is
dropped on a person.
For structural and seismic stability, the Conext XW+ Inverter/Charger must be
mounted onto a vertical supporting surface strong enough to support a
minimum of 500 lbs. (227 kg).
Failure to follow these instructions can result in death or serious injury.
AUX port
Air vent
Air filter
AUX port connector
XW-NA-Install.book Page 6 Wednesday, August 12, 2015 2:23 PM